ZyXEL Communications omni.net LCD+M User Manual

 

4-4

 

After you have connected your omni.net to the ISDN line, your computer, and analog phone 

(omi.net LCD/Plus only), then you are able to place outgoing data and voice calls. 

You can use the command [ATDI] to instruct your omni.net to make an ISDN data call. 

& Type: 

ATDI17142630398<enter>

 (Make a Data call) 

You can use your analog phone connected to Phone port 1 and 2 to dial out directly, or choose to 
type the command [ATDA], [ATDB] to instruct your omni.net that you wish to place an ISDN 
voice call. Command [ATDA] switches the call to analog port 1, while [ ATDB] assigns the call to 
analog port 2. 

& Type: 

ATDA17146930762<enter>

(Make a voice call on analog port 1) 

Using the “M” command following the “ATD” will tell your omni.net LCD+M to automatically 

switch calls to the internal fax/modem once dialing is complete. 

& Type: ATDM17146930762<enter> (Make a voice call on analog port 2) 

Your omni.net supports ISDN data utilizing Speech Bearer Service. To enable this function, you 
need to set S-register S83 bit 7 to 1 (ATS83.7=1). This function is useful in areas where ISDN 
service providers’ charge lower usage rate for voice (speech) calls.