Xerox SquareFold User Manual

SquareFold Trimmer User Guide

14

Problem solving

If a jam/fault occurs in the SquareFold Trimmer Module, a 
fault code is displayed on the Control Panel. The machine’s 
UI may also display a jam/fault message. The following 
table provides a list of fault codes for the SquareFold 
Trimmer Module and also provides a list of related finisher 
fault codes.

Fault code

Possible cause

Recommended solution

E100
E101
E102
E103
E104
E105
E106
E915
E916
E917
E918
E919

Jam/fault with the SquareFold Trimmer 
Module

Open the Top Left and Right Covers of the SquareFold 
Trimmer Module.

Important!:  The top covers cannot be opened during normal 
operation or when the machine is idle. The covers can be 
opened only when an indicator is lit (refer to page 4) and a 
jam/fault occurs within the SquareFold Trimmer Module.

If full, empty the container and reinsert it 

•

into the SquareFold Trimmer Module.
If the container is partially pulled out, push 

•

it completely in.

Carefully remove all sheets and paper scraps from jam 
clearance areas.

Close the SquareFold Trimmer Module Top Left and Right 
Covers.

Check the Trimmer Waste Container:

If necessary, follow any remaining instructions on the 
machine’s UI.

If fault persists, repeat Steps 1-5; if fault persists after that, 
call for service.