Manualsbrain.com
  1. Manuals
  2. Brands
  3. DELL
  4. 9.7(0.0)
  5. User Manual

DELL 9.7(0.0) User Manual

Download
Page of 1039
Configuring Telnet with IPv6
The Telnet client and server on a switch supports IPv6 connections. You can establish a Telnet session 
directly to the router using an IPv6 Telnet client, or you can initiate an IPv6 Telnet connection from the 
router.
• Enter the IPv6 Address for the device.
EXEC mode or EXEC Privileged mode
telnet ipv6 address
– ipv6 address: x:x:x:x::x
– mask: prefix length is from 0 to 128.
NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where 
each group is separated by a colon (:). Omitting zeros is accepted as described in 
.
SNMP over IPv6
You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive 
SNMP notifications from a device running a Dell Networking OS that supports IPv6.
The SNMP-server commands for IPv6 have been extended to support IPv6. For more information 
regarding SNMP commands, refer to the SNMP and SYSLOG chapters in the Dell Networking OS 
Command Line Reference Guide.
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Displaying IPv6 Information
To view a specified IPv6 configuration, use the show ipv6command.
• List the IPv6 show options.
EXEC mode or EXEC Privileged mode
show ipv6 ?
Example of show ipv6 Command Options
Dell#show ipv6 ?
accounting   IPv6 accounting information
cam          IPv6 CAM Entries
fib          IPv6 FIB Entries
interface    IPv6 interface information
mbgproutes   MBGP routing table
mld          MLD information
mroute       IPv6 multicast-routing table
neighbors    IPv6 neighbor information
ospf         OSPF information
pim          PIM V6 information
474
IPv6 Routing