DELL 9.7(0.0) User Manual
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
Enabling Rapid Spanning Tree Protocol Globally
Enable RSTP globally on all participating bridges; it is not enabled by default.
When you enable RSTP, all physical and port-channel interfaces that are enabled and in Layer 2 mode are
automatically part of the RST topology.
When you enable RSTP, all physical and port-channel interfaces that are enabled and in Layer 2 mode are
automatically part of the RST topology.
• Only one path from any bridge to any other bridge is enabled.
• Bridges block a redundant path by disabling one of the link ports.
• Bridges block a redundant path by disabling one of the link ports.
To enable RSTP globally for all Layer 2 interfaces, use the following commands.
1.
Enter PROTOCOL SPANNING TREE RSTP mode.
CONFIGURATION mode
CONFIGURATION mode
protocol spanning-tree rstp
2. Enable RSTP.
PROTOCOL SPANNING TREE RSTP mode
no disable
Examples of Viewing RSTP Information
To disable RSTP globally for all Layer 2 interfaces, enter the disable command from PROTOCOL
SPANNING TREE RSTP mode.
To verify that RSTP is enabled, use the show config command from PROTOCOL SPANNING TREE RSTP
mode. The bold line indicates that RSTP is enabled.
SPANNING TREE RSTP mode.
To verify that RSTP is enabled, use the show config command from PROTOCOL SPANNING TREE RSTP
mode. The bold line indicates that RSTP is enabled.
Dell(conf-rstp)#show config
!
protocol spanning-tree rstp
no disable
Dell(conf-rstp)#
Rapid Spanning Tree Protocol (RSTP)
769