DELL 9.7(0.0) User Manual

Tunneling

Tunnel interfaces create a logical tunnel for IPv4 or IPv6 traffic. Tunneling supports RFC 2003, RFC 2473,
and 4213.
DSCP, hop-limits, flow label values, OSPFv2, and OSPFv3 are also supported. ICMP error relay, PATH MTU
transmission, and fragmented packets are not supported.

Configuring a Tunnel

You can configure a tunnel in IPv6 mode, IPv6IP mode, and IPIP mode.

• If the tunnel mode is IPIP or IPv6IP, the tunnel source address and the tunnel destination address

must be an IPv4 address.

• If the tunnel mode is IPv6, the tunnel source address and the tunnel destination address must be an

IPv6 address.

• If the tunnel mode is IPv6 or IPIP, you can use either an IPv6 address or an IPv4 address for the logical

address of the tunnel, but in IPv6IP mode, the logical address must be an IPv6 address.

The following sample configuration shows a tunnel configured in IPv6 mode (carries IPv6 and IPv4

traffic).
Dell(conf)#interface tunnel 1

Dell(conf-if-tu-1)#tunnel source 30.1.1.1

Dell(conf-if-tu-1)#tunnel destination 50.1.1.1

Dell(conf-if-tu-1)#tunnel mode ipip

Dell(conf-if-tu-1)#ip address 1.1.1.1/24

Dell(conf-if-tu-1)#ipv6 address 1::1/64

Dell(conf-if-tu-1)#no shutdown

Dell(conf-if-tu-1)#show config

interface Tunnel 1

ip address 1.1.1.1/24

ipv6 address 1::1/64

tunnel destination 50.1.1.1

tunnel source 30.1.1.1

tunnel mode ipip

no shutdown

The following sample configuration shows a tunnel configured in IPV6IP mode (IPv4 tunnel carries IPv6
traffic only):
Dell(conf)#interface tunnel 2

Dell(conf-if-tu-2)#tunnel source 60.1.1.1

Dell(conf-if-tu-2)#tunnel destination 90.1.1.1

Dell(conf-if-tu-2)#tunnel mode ipv6ip

Dell(conf-if-tu-2)#ipv6 address 2::1/64

Dell(conf-if-tu-2)#no shutdown

Dell(conf-if-tu-2)#show config

896

Tunneling