DELL 9.7(0.0) User Manual
NOTE: You cannot assign an IP address to the Default VLAN (VLAN 1). To assign another VLAN ID to
the Default VLAN, use the default vlan-id vlan-id command.
the Default VLAN, use the default vlan-id vlan-id command.
You can place VLANs and other logical interfaces in Layer 3 mode to receive and send routed traffic. For
more information, refer to
more information, refer to
.
To assign an IP address, use the following command.
• Configure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
– ip-address mask — Enter an address in dotted-decimal format (A.B.C.D) and the mask must be
in slash format (/24).
– secondary — This is the interface’s backup IP address. You can configure up to eight secondary
IP addresses.
Configuring Native VLANs
Traditionally, ports can be either untagged for membership to one VLAN or tagged for membership to
multiple VLANs.
You must connect an untagged port to a VLAN-unaware station (one that does not understand VLAN
tags), and you must connect a tagged port to a VLAN-aware station (one that generates and understands
VLAN tags).
Native VLAN support breaks this barrier so that you can connect a port to both VLAN-aware and VLAN-
unaware stations. Such ports are referred to as hybrid ports. Physical and port-channel interfaces may be
hybrid ports.
Native VLAN support breaks this barrier so that you can connect a port to both VLAN-aware and VLAN-
unaware stations. Such ports are referred to as hybrid ports. Physical and port-channel interfaces may be
hybrid ports.
Native VLAN is useful in deployments where a Layer 2 port can receive both tagged and untagged traffic
on the same physical port. The classic example is connecting a voice-over-IP (VOIP) phone and a PC to
the same port of the switch. The VOIP phone is configured to generate tagged packets (with VLAN =
VOICE VLAN) and the attached PC generates untagged packets.
on the same physical port. The classic example is connecting a voice-over-IP (VOIP) phone and a PC to
the same port of the switch. The VOIP phone is configured to generate tagged packets (with VLAN =
VOICE VLAN) and the attached PC generates untagged packets.
NOTE: When a hybrid port is untagged in a VLAN but it receives tagged traffic, all traffic is accepted.
NOTE: You cannot configure an existing switchport or port channel interface for Native VLAN.
Interfaces must have no other Layer 2 or Layer 3 configurations when using the portmode hybrid
command or a message similar to this displays: % Error: Port is in Layer-2 mode Te
5/6.
5/6.
To configure a port so that it can be a member of an untagged and tagged VLANs, use the following
commands.
commands.
1.
Remove any Layer 2 or Layer 3 configurations from the interface.
INTERFACE mode
INTERFACE mode
2. Configure the interface for Hybrid mode.
INTERFACE mode
portmode hybrid
3. Configure the interface for Switchport mode.
INTERFACE mode
Virtual LANs (VLANs)
919