DELL 9.7(0.0) User Manual
Task
Command Syntax
Command Mode
View VRRP command
output for the VRF vrf1
output for the VRF vrf1
show vrrp vrf vrf1
------------------
TenGigabitEthernet 1/13, IPv4
VRID: 10, Version: 2, Net:
10.1.1.1
VRF: 2 vrf1
State: Master, Priority: 100,
Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE,
AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0,
Adv sent: 43, Gratuitous ARP
sent: 0
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.1.1.100
Authentication: (none)
Configuring Management VRF
You can assign a management interface to a management VRF.
Task
Command Syntax
Command Mode
Create a management VRF.
ip vrf management
CONFIGURATION
Assign a management port to a
management VRF.
management VRF.
interface management
VRF MODE
Configuring a Static Route
To configure a static route, perform the following steps:
Task
Command Syntax
Command Mode
Configure a static route that
points to a management
interface.
points to a management
interface.
management route ip-
address mask
managementethernet
address mask
managementethernet
ormanagement route ipv6-
address prefix-length
managementethernet
address prefix-length
managementethernet
NOTE: You can also have
the management route to
point to a front-end port in
case of the management
VRF. For example:
the management route to
point to a front-end port in
case of the management
VRF. For example:
management route 2::/64 te
0/0.
CONFIGURATION
To configure a static entry in the IPv6 neighbor discovery, perform the following steps:
928
Virtual Routing and Forwarding (VRF)