Avocent EMS1000P User Manual

Emerge EMS Installer/User Guide

 

Chapter 2: Installation

NOTE: Please observe the recommended overall link cable lengths (including receiver cascade 

connections) in order to avoid signal degradation.

1.  Attach the connector of the cascade link cable to the socket labeled 

 on the primary Emerge EMS1000MP-R receiver. 

2.  At the other end of the cascade link cable, attach the 

connector to the socket labeled 

 on the 

secondary Emerge EMS1000MP-R receiver.

 

In all cases, there should be a click when 

the cable is fully inserted and locked in 

place.

3.  If necessary, repeat the above procedure 

for a tertiary Emerge EMS1000MP-R 

receiver.

4.  Connect the remaining signal 

and power cables to the 

added receivers, as 

discussed earlier 

within this 

chapter. 

 

Figure 2.20: Connecting the link output of one 

receiver to the link input of the next