Epson Epson User Manual

Your system comes with two externally accessible drive bays.
You can install any type of drive in these bays, including
internal hard disk drives.

If you are installing a hard disk drive or another IDE device,

be sure its jumper(s) are set correctly for your configuration.
A table in the “Information for Qualified Hard Disk Drives”

section of Appendix A lists the master and slave jumper
settings for high-capacity, EPSON-qualified IDE hard disk

drives. If your drive is not listed or you need more information,

see the documentation that came with your drive or contact the

manufacturer.

Note

You must connect IDE CD-ROM drives or other devices to

the secondary IDE interface. Use the primary interface only
for IDE hard disk drives. You cannot connect a CD-ROM

drive and hard disk drive to the same interface.

Before you can install a drive in one of the external bays, you

must remove the mounting bracket containing the diskette

drive (and possibly a hard disk drive). Follow the instructions

under “Removing the Drive Mounting Bracket.” (You can
remove the bracket and drives without disconnecting the drive

cables.)

This section includes steps for the following procedures:

Attaching mounting frames to the drive (if necessary)

Installing the drive in the bay

Connecting the drive cables.