Telex BP-2002 User Manual
13
4
Figure 1. BP-2002 & BP-1002 Connections and Controls
APPENDIX A
OPTIONAL FOOTBALL MODIFICATIONS
GENERAL DESCRIPTION
In Audiocom
In Audiocom
®
Intercom Systems, the Mic-Kill feature is used to turn off any activated
microphones on a selected channel. The Mic-Kill feature is activated when the beltpack
receives a 24 kHz signal from the channel. In some applications the Mic-Kill and Call
signal features are not desired and need to be disabled.
receives a 24 kHz signal from the channel. In some applications the Mic-Kill and Call
signal features are not desired and need to be disabled.
ELIMINATING MIC-KILL AND CALL SIGNAL
CAUTION
TO PREVENT DAMAGE TO THE EQUIPMENT, THESE MODIFICATIONS SHOULD ONLY
BE MADE BY QUALIFIED TECHNICIANS.
BE MADE BY QUALIFIED TECHNICIANS.
If desired, the Mic-Kill and Call signal features can be disabled in the BP-2002/BP-1002 by
removing a surface-mounted capacitor from the printed circuit board. Perform the following:
removing a surface-mounted capacitor from the printed circuit board. Perform the following:
1.
Before making changes to the printed circuit board,
disconnect all power and line connections from the beltpack.
disconnect all power and line connections from the beltpack.
2.
Refer to Figure 3 and locate C61 on the underside of
the printed circuit board.
the printed circuit board.
3.
Remove capacitor C61 from the printed circuit board.
RESTORING MIC-KILL AND CALL SIGNAL
To restore the Mic-Kill and Call signal features, replace C61 with Telex
®
part number
102881-140, 1500 pF, 50V capacitor.