National Instruments 3.22E+04 User Manual

Index

PCI Serial for Windows Me/9x

I-2

ni.com

D

data bits, 3-3
DB-25 connector, 2-10

pin descriptions (table), 2-10
pin locations (figure), 2-10

DB-9

100-pin connector pin descriptions

100-pin connector pin descriptions

68-pin connector pin descriptions

68-pin connector pin descriptions (table),

connector, 2-8
pin descriptions (table), 2-8
pin locations (figure), 2-8

DCE vs. DTE, A-7
default restoration, 3-4
determining port associated with COMx, C-6
determining type of serial hardware

determining version of NI-Serial software

development tools for saving time, 1-4
device manager ports list (figure), C-5
device manager tab for PCI serial board ports

DeviceloControl, 4-4

input values (table), 4-5
setting transceiver mode with, 4-4

diagnostic messages, C-2

address test failed, C-4
diagnostic utility does not show all

installed ports, C-3

interrupt test failed, C-4
no National Instruments serial port

troubleshooting, C-2

diagnostic test failure, C-6
DOS-based addresses (table), C-7

DTE vs. DCE, A-7
DTE-to-DCE interface, A-7

straight-through cabling in (figure), A-7

DTE-to-DTE interface, A-7

null-modem cabling in (figure), A-7

duplex architectures, A-3

full duplex, A-3
half duplex, A-4

E

eight-port boards specifications, D-3
environmental characteristics, D-4

F

FIFO buffers, 3-4
flow control, 3-3
forcing Windows to detect hardware, C-4
four-port boards

connecting cables to (figure), 2-11
isolated four-port boards, D-2
specifications, D-2

four-wire mode, 4-2
freeing an interrupt request level, C-1
full duplex, A-3

full-duplex system (figure), A-4

G

general programming requirements, 4-1
getting started, 1-2
glossary, G-1

half duplex, A-4

half-duplex system (figure), A-4

hardware installation, 2-3

getting started, 1-2
verification, 2-5