Nortel Networks 8683POS User Manual
124
Chapter 6 Command line interface
209564-A
show tech command
The
show tech
command has the following syntax:
show tech
shows sample output for the show tech command.
Table 51 Information fields for output of the show ports stats pos sonetmediumtbl
command
command
Field Description
PORT NUM
Port number.
MEDIUM TYPE
Identifies whether a sonet or sdh signal is used across the
interface.
interface.
TIME ELAPSED
Number of seconds, including partial seconds, that have
elapsed since the beginning of the current measurement
period. If the current interval exceeds the maximum value,
the agent will return the maximum value.
elapsed since the beginning of the current measurement
period. If the current interval exceeds the maximum value,
the agent will return the maximum value.
VALID INTERVALS
Number of previous 15-minute intervals for which data was
collected.
collected.
LINE CODING
Line coding for this interface. The B3ZS and CMI are used
for electrical SONET/SDH signals (STS-1 and STS-3). The
Non-Return to Zero (NZR) and the Return to Zero are used
for optical SONET/SDH signals.
for electrical SONET/SDH signals (STS-1 and STS-3). The
Non-Return to Zero (NZR) and the Return to Zero are used
for optical SONET/SDH signals.
LINE TYPE
Line type for this interface. The line types are Single Mode
fiber or Multi-Mode fiber interfaces.
fiber or Multi-Mode fiber interfaces.
CIRCUIT ID
Transmission vendor’s circuit identifier, to facilitate
troubleshooting.
troubleshooting.