Nortel Networks 8683POS User Manual
54
Chapter 4 Managing the Passport 8683POS Module
209564-A
Configuration procedures
You can configure the Passport 8683POS Module in two basic modes:
•
Bridging: Bridging mode is enabled by default. Bridging is configured for
connections between two Passport 8683POS Modules and between Passport
8683POS Modules and other devices that support PPP bridging.
connections between two Passport 8683POS Modules and between Passport
8683POS Modules and other devices that support PPP bridging.
•
Routing: You select routing mode for connections between your Passport
8683POS Module and other POS-capable routers for IP and IPX routing.
8683POS Module and other POS-capable routers for IP and IPX routing.
Use Device Manager and/or CLI to perform these configuration and related tasks
on the Passport 8683POS Module. For information on advanced configurations,
refer to Getting Started with Passport 8000 Series Management Software.
on the Passport 8683POS Module. For information on advanced configurations,
refer to Getting Started with Passport 8000 Series Management Software.
This section describes the following:
•
next
•
•
Default configurations
The Passport 8683POS Module has the following default configurations.
Table 9 Passport 8683POS Module default settings
Parameter
Default
Bridge Admin State (BCP)
Open
IP Admin State (IPCP)
Close
IPX Admin State (IPXCP)
Close
Clock source
Line
FCS size
32
Debug
Disabled
Framing
SONET
Priority
Low