Nortel Networks 8683POS User Manual
92
Chapter 6 Command line interface
209564-A
Configuration commands
This section describes the configuration commands available with the Passport
8683POS Module. There are two types of configuration commands:
8683POS Module. There are two types of configuration commands:
•
Module commands
•
Port commands
config poscard commands
The
config poscard
command allows you to:
•
Reset the module
•
Enable trace messages
•
Display the image filename for the Passport 8683POS Module
The syntax is:
config poscard
<posslot number>
where
<posslot number>
is the slot number of the module in the Passport 8600
chassis.
Table 30 describes the parameters and variables for the config poscard
command.
command.
Note:
If you replace one card with another type of card, Nortel
Networks recommends that you go to the root level of the CLI directory
before you use any CLI commands.
before you use any CLI commands.