Nortel Networks 1750 User Manual

Chapter 1 Cables and power 25

Nortel VPN Router Installation — VPN Router 1750 

Press and release the power switch on the rear of the VPN Router 1750, and 
wait for the gateway to start.

After you connect the gateway to the power source and turn it on, you can verify a 
successful installation by checking the light emitting diodes (LED) on the front 
panel. For more information, see 

.

The following sequence of LEDs occurs:

The power LED (the Nortel logo) lights blue.

The Alert LED lights red and the Boot/Ready LED lights green.

When the gateway begins the boot sequence, the Boot/Ready LED lights 
yellow and the Alert LED turns off.

After the boot process is complete, the Boot/Ready LED lights green, which 
indicates that the gateway is operational.

The Alert LED lights yellow because the gateway is not configured.

For a newly installed VPN Router 1750, a yellow Alert LED does not indicate 
an alarm condition. After you configure the gateway, the Alert LED turns off. 
For more information, see 

If the LEDs on the front panel light in the preceding sequence, the installation is 
successful. If the LEDs do not light in the preceding sequence, check that you 
correctly installed the bezel on the gateway and that you properly attached the 
power cord to the power supply. For more information, see 

.

If the VPN Router 1750 still does not start, contact your local Nortel Technical 
Solutions Center. For more information, see