Motorola IH5 User Manual

Getting Started

http://www.motorola.com/computer/literature

1-3

This section provides an overview of the steps necessary to install and 
power up the MCPN750A, any additional equipment requirements, and a 
brief section on unpacking and ESD precautions. As identified in the table 
below, several steps can be omitted if your board, for example, has been 
shipped with PMCs and Flash already installed

The following table lists the things you will need to do before you can use 
this board and tells where to find the information you need to perform each 
step. Be sure to read this entire chapter, including all Caution and Warning 
notes, before you begin.

Unpack the hardware.

Configure the hardware by 
setting jumpers on the baseboard 
and transition module.

MCPN750A Baseboard Preparation and 
TMCPN710 or TM-PIMC-0001 Transition Module 
Preparation 

and 

Ensure CompactFlash card is 
installed (if required)

Compact Flash Memory Card Installation

Install the PMC Module (if 
required)

Install the MCPN750A in the 
chassis.

Install the transition module in 
the chassis.

 TMCPN710 or TM-PIMC-0001 Transition Module 
Installation

Connect any other equipment 
you will be using.

For more information on optional devices and 
equipment, refer to the documentation provided with 
the equipment.

Power up the system.