Sony 4-127-580-13(1) User Manual
ICD-SX700/SX800 4-127-580-11(1)
1
GB
When you use the IC recorder for the
first time, or after you have not used
the IC recorder for a certain time, it
is recommended that you charge
the batteries repeatedly until “
” is
displayed.
If the battery indicator is not displayed,
If the battery indicator is not displayed,
charging has not been done properly.
Proceed from step 1 again.
* This is an approximation for the time
it takes to charge from no remaining
battery power to full battery power at
room temperature. It varies depending on
the remaining power and the condition
of the batteries. It also takes more time if
the temperature of the batteries is low, or
if the batteries are charged while you are
transferring data to the IC recorder.
Disconnecting the IC
recorder from the AC outlet
Follow the procedures below; otherwise,
data may be damaged.
1
If you are recording or playing back
a message, press (stop) to put the
IC recorder into the stop mode.
2
Make sure that the operation
indicator is not flashing.
3
Disconnect the USB AC adaptor
from the AC outlet, then disconnect
the IC recorder from the USB AC
adaptor.
Notes
While “
” or “
” is being displayed
instead of the battery indicator, you cannot
charge the batteries. Charge the batteries in
an environment with a temperature of 5 °C
–35 °C.
While playing back messages using the built-
While playing back messages using the built-
in speaker, you cannot charge the batteries.