ZyXEL Communications n/a User Manual

DSL & IAD CLI Reference Guide

Use these commands to configure system related settings on the ZyXEL Device.

The following section lists the commands for this feature.

The following table describes input values for some of the sys commands. Other values are 
discussed with the corresponding commands.

Table 43   sys Command Input Values

The SNMP community (or password).

Describes the result of a comparison of a packet field with that specified in a rule. 
There are four possible values:

0:None -

Do not compare the packet field with that specified in the rule.

1:Equal -

The packet field value is the same as that specified in the rule.

2:NotEqual -

The packet field value is not the same as that specified in the 

rule.

3:Less -

The packet field value is less than that specified in the rule.

4:Greater -

The packet field value is greater than that specified in the rule.

Sets the action when a filter set is checking a packet. The options are:

forward:

 This forwards the packet to its destination.

drop: 

This drops the packet. 

checknext: 

Sets the filter to check the next rule. Use this option if the packet 

must be checked against more than one rule. 

The number of a tripleplay port-interface group mapping policy.

An interface on the ZyXEL Device. These are usually as follows:

enif0

: LAN

enif1

: WAN

wanif0

: PPPoE 

If the device supports WLAN then:

enif1

: WLAN

enif2

: WAN

An e-mail address

<32 ASCII characters

A list of port numbers.

0 = ICMP, 6 = TCP, 17 = UDP