ZyXEL Communications n/a User Manual

 Chapter 19 System Commands

DSL & IAD CLI Reference Guide

sys tripleplay igmpsnp 

maxresptime [tenthsofasecond]

Displays or sets the maximum response time for a IGMP membership 
query in tenths of a second. 
This is used to determine the total group timeout value.
IGMP Group Timeout = (Robustness x Query Interval) + (Max 
Response Time/10) + Time Value.(default = 2).

sys tripleplay igmpsnp 

queryinterval [seconds]

Displays or sets the IGMP query interval time in seconds.
This is used to determine the query timeout value.
IGMP Query Timeout = (Robustness x Query Interval) + (Max 
Response Time/20) + Time Value (default = 2).

sys tripleplay igmpsnp robust 

[robustness]

Displays or sets the level of robustness. 

: This variable represents the level of expected packet 

loss on the subnet. The range is 2-255.
This is used to determine the leave timeout:
IGMP Leave Timeout = Robustness x Max Response Time/100 + 3

sys tripleplay portbase disable

Disables port-based tripleplay services. 

sys tripleplay portbase display

Displays the permanent virtual circuit (PVC) to port mappings for 
tripleplay services such VoIP or video.

sys tripleplay portbase enable

Enables port-based tripleplay services.

sys tripleplay portbase groupadd 

[groupid][LAN[ports]][PVC[ports]

][WLAN[ssid]]

Adds ports and/or interfaces to a group mapping policy.

sys tripleplay portbase groupdel 

[groupid][LAN[ports]][PVC[ports]

][WLAN[ssid]]

Deletes the whole group or individual members.

sys tripleplay portbase groupset 

[groupid][LAN[ports]][PVC[ports]

][WLAN[ssid]]

Sets a group port to PVC mapping policy, with up to eight PVCs 
allowed. WLAN may only belong to one group. 
If a product supports multiple SSID, each one will be treated as if it 
were a port.

sys tripleplay portbase save

Saves the port mappings to non-volatile memory.

sys tripleplay portbase set 

<port><pvcid|disable>

Sets a single port to single PVC mapping policy. 

: The number of the PVC, between 1-8.

sys upnp active [0:no|1:yes]

Activates or deactivates the saved UPnP settings.

sys upnp config 

[0:deny|1:permit]

Allows users to make configuration changes through UPnP.

sys upnp display

Displays the UPnP configuration.

sys upnp firewall 

[0:deny|1:pass]

Allows UPnP to pass through the firewall.

sys upnp load 

Loads the UPnP setting buffer. Use this command to be able to 
configure the settings. Use sys upnp save after you configure the 
settings.

sys upnp reserve 

[0:deny|1:permit]

Retains UPnP created NAT rules even after restarting.

sys upnp save

Saves the UPnP settings to the long term memory. 

sys userPassword <password>

Changes the user password.
This command may not be supported in your ZyXEL Device.

sys version

Displays the firmware and bootbase versions.     

Table 44   sys Commands (continued)