Barco 26-0405000-00 User Manual

Output Setup

Please note the following important output setup prerequisite:

Ensure that you know your projector’s native resolution.  Refer to your projector’s 
technical manual for details.

„

Use the following steps to set up the PresentationPRO-II output.   

1.  From the Home Menu, press {OUTPUT} to access the Output Menu.  

2.  On the Format line, select your projector’s native resolution, and a frame rate that 

is consistent with your inputs.

S

Example:  If you are using 59.94 NTSC video inputs, run the output at the 
same rate in order to be synchronous.  

In Appendix A, refer to the “

“ section on page 129 

for details on all available resolutions.

3.  After selecting a format, press {SELECT FORMAT} to “accept” the selection.  

4.  Press {SAVE} to save all output settings in the output file.

Please continue with the “

” section on page 88.

Please note the following important projector setup prerequisite:

Ensure that you are familiar with the 

Output Setup Menu and all sub menus 

included on that screen.  In Chapter 4, refer to the “

” 

section on page 40 for details.

„

Use the following steps to set up your projector.   

1.  From the Home Menu, press {OUTPUT} to access the Output Menu.  

2.  Press {TEST PATTERN} to access the Test Pattern Menu.

a.  Scroll to the Type line and select the Burst test pattern.

b.  Scroll to the Raster Box line and enable the Raster Box.

c.  At the projector itself, perform the following adjustments to ensure that 

the PresentationPRO-II output data is properly displayed:

•

Adjust the image for a minimum amount of noise

•

Adjust the image such that the entire Raster Box is visible. 

d.  Once the projector is properly set, disable the Raster Box and select the 

100% Color Bars test pattern.

The PresentationPRO-II output format must match your 
projector’s native resolution.

Refer to your projector’s technical manual for information on 
all projector setup and adjustment procedures.