Barco 26-0405000-00 User Manual

Using Remote Control

When PresentationPRO-II is controlled from an external controller, the 

Menu is used to set the unit ID and enable/disable remote control itself.  Please note the 
following prerequisites:

Ensure that you know the unit IDs currently in use by the external controller.  The 
external controller will not allow PresentationPRO-II to connect if a duplicate ID is 
assigned.

If an external router is to be connected to PresentationPRO-II, ensure that the 
proper physical connections have been made, and that the router is properly 
configured from the external controller. 

„

Use the following steps to place PresentationPRO-II under remote control:

1.  Press {HOME} > {REMOTE CONTROL} to access the Remote Control Menu.  

2.  Set the Unit ID to a value that is not used within the external controller’s system.    

3.  Scroll to the Remote Control line turn it ON.  

4.  In the “Status” section, verify the following:

Connection status with the external controller.

Ctrlr IP —  the IP address of the external controller.

Destination — the destination assigned to PresentationPRO-II.

Router — the utilization of routers, either internal or external.

„

Use the following steps to reestablish local PresentationPRO-II control:

1.  On the Remote Control Menu, scroll to the Remote Control line turn it OFF.  The 

{

HOME} buttons reappears, the PresentationPRO-II front panel is re-enabled, and 

all control now originates locally.

When remote control is on, the {

HOME} buttons disappears, 

the PresentationPRO-II front panel is disabled, and all control 
originates from the external controller.