Barco 26-0405000-00 User Manual
12
PresentationPRO-II • User’s Guide
2. Hardware Orientation
PresentationPRO-II Rear Panel
mêÉëÉåí~íáçåmolJff=oÉ~ê=m~åÉä
The figure below illustrates the PresentationPRO-II rear panel:
Figure 2-1. PresentationPRO-II Rear Panel
Following are descriptions of each rear panel connector and section.
1)
SDI Input
One BNC connector is provided for an SD-SDI/HD-SDI input (HD model) or an
SD-SDI
SD-SDI
input (SDI model). This input is directly associated with the SDI source
button on the front panel’s top row.
Users can set the input to accept the following:
~
SDI
(SMPTE 259M-C, NTSC or PAL). SDI and HD models.
~
HD-SDI
(SMPTE 292M, HDTV). HD model only.
In Chapter 5, refer to the “
” section on page 90 for
input setup instructions.
2) Analog
Inputs
Eight 15-pin D connectors are provided for Analog Inputs. These numbered
inputs feed the system’s internal 8 x 1 analog router, and correspond directly to
the eight analog source buttons on the front panel.
inputs feed the system’s internal 8 x 1 analog router, and correspond directly to
the eight analog source buttons on the front panel.
Please note:
~
In Appendix A, refer to the “
” section on
page 126 for pinout details.
~
Refer to the “
” section on page 14 for additional
information about each analog input connector.
6
7
3
1
2
4
5
1)
4)
7)
2)
5)
3)
6)