Barco 26-0405000-00 User Manual
PresentationPRO-II • User’s Guide
35
4. Menu Orientation
Input Menu
páòáåÖ=jÉåì
From the
Input Menu, press {SIZING} to display one of two Sizing Menus. These menus
are context sensitive — they change depending on the
Sampling Mode selected on the
Input Menu.
•
If
1:1 Sampling is selected, the
appears.
•
If
Oversample is selected, the
appears.
Each menu and function is described below.
NWN=páòáåÖ=jÉåì
The figure below illustrates a sample
1:1 Sizing Menu.
Figure 4-7. 1:1 Sizing Menu (sample)
•
Clock Phase — sets the system’s A/D converter, allowing you to select where
pixels are sampled (ideally, on the pixel’s peak). The adjustment range is
pixels are sampled (ideally, on the pixel’s peak). The adjustment range is
-16 to
15. For optimum visual results when adjusting high-resolution computer sources,
project a burst test pattern and adjust the sampling for the minimum noise. Refer
to the “
project a burst test pattern and adjust the sampling for the minimum noise. Refer
to the “
” section on page 42 for information.
•
H Total — sets the total pixel count per line.
•
H Active — sets the width of the active area.
•
H Position — sets the start of the active area’s horizontal offset from H sync.
•
V Total — fixed value which cannot be adjusted.
•
V Active — sets the number of vertical lines in the image.
•
V Position — sets the start of the active area’s vertical offset from V sync.
•
Press
{SAVE} to save the selected input in the designated input file.
H Active
H Position
V Total
H Total
V Active
V Position
[ 858 ]
720
[ 0 ]
486
36
H
O
O
M
E
N
A
V
A
V
A
D
D
J
1:1 SIZING
SRC_3
Clock Phase
0
123
S
A
V
E
A
V
E
B
A
C
K
A
C
K
Note
This field is not adjustable for digital sources (including both
the DVI and BNC input connectors), or for NTSC and PAL
sources, regardless of connection type.
the DVI and BNC input connectors), or for NTSC and PAL
sources, regardless of connection type.