Sanyo POA-PN03C User Manual

 

If some of the registered projectors are disabled by 
some reasons (such as disconnecting the power source, 
disconnecting the LAN cable, disconnecting from the 
network), control changes will continue to be effective 
for the projectors that are still active. At the same time, 
the deactivated projectors are excluded from the multi-
control. The status of the registered projectors are indi-
cated under the projector name. See the table below 
for status indications.

✐

  If the multi-controlled projector is in the standby mode, any change is not effective except timer 

setting.

✐

  Cannot register, delete or change the multi-control setting during using the network viewer func-

tion.

✐

  It is recommended that a specified projector should be chosen for setting as a master when you 

use this multi-control function. The control for the multi-controlled projectors will become too 

complicated operation if this function is used for each projector.

✐

  If the registered projector is not connected to the network, it will take some time to complete the 

multi-control operation because of waiting for the response from each registered projector.

✐

  There are some disabled items in the multi-control function for the light mode.

To change the mode of the registered projector, select a mode with the pull-down menu 
button under the IP address of the target projector and then click Set button.

(blank) ..................... The projector is connected to the network correctly

No connect .......... The projector may not be connected to the network. Please check the connection 

and network configuration of this projector.

PIN code error ............. The PIN code is incorrect. The PIN code for the multi-controlled projectors must be 

the same. Change the PIN code of this projector to the common PIN code.

File Error.................  Not displaying the images. Check if this projector is using the Network Capture 

function or Network Viewer function individually, or  in the standby mode.

* The network unit updates the status at the time when the multi-control function was executed. 

Control .................... Controlling the projector

Control & Image .........  Controlling and displaying images

Image ...................... Displaying the images

OFF ............................ Excluding from the multi-control

Delete ...................... Deleting from the multi-control

Status

*  The multi control item is not changed during using the 

network viewer function. It is not available with the light 

mode.