Nortel Networks P0886629 User Manual
Appendix B: Dialing Translation 65
P0886629 Issue 1.0
FAX Set Up and Operation Guide
Changing an entry in the Dialing Translation Table
After a Dialing Translation Table has been built, you can change the Output value
of an entry at any time. To locate the entry that you wish to change, refer to
of an entry at any time. To locate the entry that you wish to change, refer to
Note: You cannot change the Input value of an entry. The entry must be deleted
and a new entry must be created with new Input and Output values. Refer to
To change an entry in the Dialing Translation Table:
1. Press
ƒ
·
°
‹.
2. Enter the System Coordinator Mailbox number and
password and press OK.
3. Press
°
°.
4. Press TABLE. If Centrex is installed on your Norstar
system, QUIT is replaced by NEXT.
5. Press CHNG.
6. Press OTHR. inval* outval* is an example of a
Table entry. The * character shown after a value
signifies any digits in the telephone number
remaining to be dialed. Norstar Voice Mail
automatically adds the * character after every Input
and Output value.
signifies any digits in the telephone number
remaining to be dialed. Norstar Voice Mail
automatically adds the * character after every Input
and Output value.
7. Press CHNG.
8. Enter the new Output value and press OK.
9. Repeat steps 6 through 8 to change any other entries
in the Dialing Translation Table.
10. Press
® to end this programming session.
Log:
QUIT RETRY
QUIT RETRY
Admin
MBOX AA OTHR
MBOX AA OTHR
Dialing
PARM
PARM
QUIT
Dial table
ADD
ADD
QUIT
inval
*
outval
*
NEXT
inval
*
outval
*
DEL FIND
Out:
RETRY
RETRY
inval
*
outval
*
NEXT OTHR