Acer 61X User Manual
2-100
Service Guide
•
+2.35V:(2.45V) Load
: 0A-4.2A
Regulation: +5%, -4%
•
Ripple:
50mA (max)
•
Noise:
100mV (max)
•
OVP:
3.3-5.0V
•
Short-circuit protection
•
Fuse protection
•
*Ripple(max)=75mV when regulate in IDLE mode
•
+12V
: Load : 0A-0.15A
Regulation: +/-5%
•
Ripple:
100mV (max)
•
Noise:
200mV (max)
•
OVP:
14-20V
•
*The +12V max load condition is available only when the +5V output load is greater than
0.5A.
•
+6V
: Load : 0A~0.1A
Regulation: 5.5V~7.5V
•
Ripple:
300mV (max)
•
Noise:
500mV (max)
•
OVP:
7-9 V
•
*The +6V max load condition is available only when the +5V output load is greater than
0.5A.
•
5VSB:Load
: 5mA
Regulation:+/-10%
•
Ripple: 75mV(max)
Noise: 250mV(max)
•
P.G. :Active high within 100ms to 500ms after system
’s +5V, 3.3V and Vcpu are all in
regulation.
•
Driving capability:12uA(source)
200uA(sink)
2.10.4
Control
•
VCPU Control:
Control switch can switch Vcpu output voltage to 2.35V2.45V2.9 or 3.1V.
•
ON/OFF:
A logic low will turn off +5V,+3.3V, 2.35V/2.45V/2.9V/3.1V,+12V and +6V
main o/p. The DC/DC converter draws about 30uA when the notebook computer is in
shutdown mode.
shutdown mode.
2.10.5
Application:
Input filter capacitor
The recommended value is two pieces of 10uf/50V ceramic capacitor(or the same grade
capacitor, such as SANYO OS-CON capacitor) with less than 150mohm ESR. And it should be
located less than 10mm away from DCBATT_IN pin.
capacitor, such as SANYO OS-CON capacitor) with less than 150mohm ESR. And it should be
located less than 10mm away from DCBATT_IN pin.