ZyXEL Communications IES-612-51A User Manual
Chapter 27 RFC 2684 Routed Mode
IES-612-51A User’s Guide
200
Figure 99 RPVC Arp Proxy
The following table describes the labels in this screen.
27.5 2684 Routed Gateway Screen
Use this screen to configure gateway settings.
To open this screen, click Advanced Application, 2684 Routed Mode, Routed Gateway.
Table 61 RPVC Arp Proxy
LABEL
DESCRIPTION
Routed Domain
Click Routed Domain to open this screen where you can configure domains for
2684 routed mode traffic (see
2684 routed mode traffic (see
).
Routed Gateway
Routed PVC
Aging Time
Enter a number of seconds (10~10000) to set how long the device keeps the
Address Resolution Protocol table’s entries of IP addresses of CPE devices
using 2684 routed mode. Enter 0 to disable the aging time.
Address Resolution Protocol table’s entries of IP addresses of CPE devices
using 2684 routed mode. Enter 0 to disable the aging time.
Apply Setting
Click Apply Setting to save your changes to the IES-612-51A’s volatile
memory.
The IES-612-51A loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
memory.
The IES-612-51A loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Index
This field displays the number of the IP address entry.
Gateway IP
This field displays the IP address of the gateway to which the device sends the
traffic that it receives from this entry’s IP address.
traffic that it receives from this entry’s IP address.
VID
This field displays the VLAN Identifier that the device adds to Ethernet frames
that it sends to this gateway.
that it sends to this gateway.
MAC
This field displays the subscriber’s MAC (Media Access Control) address.
Flush
Click Flush to remove all of the entries from the ARP table.