ZyXEL Communications IES-612-51A User Manual
Chapter 46 MAC Commands
IES-612-51A User’s Guide
308
46.2.2 MAC Filter Enable Command
Syntax:
ras> switch mac filter enable [portlist]
where
This command turns on the MAC filtering feature on the specified DSL port(s) or on all DSL
ports if no port is specified.
ports if no port is specified.
The following example turns on the MAC filtering feature on DSL port 5.
46.2.3 MAC Filter Disable Command
Syntax:
ras> switch mac filter disable [portlist]
where
This command turns off the MAC filtering feature on the specified DSL port(s) or on all DSL
ports if no port is specified.
ports if no port is specified.
The following example turns off the MAC filtering feature on DSL port 5.
46.2.4 MAC Filter Mode Command
Syntax:
ras> switch mac filter mode <port> <accept|deny>
where
[portlist]
=
You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
Figure 162 MAC Filter Enable Command Example
ras> switch mac filter enable 5
[portlist]
=
You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
Figure 163 MAC Filter Disable Command Example
ras> switch mac filter disable 5
<accept|deny>
=
accept = Only allow frames from MAC addresses that you
specify and block frames from other MAC addresses.
specify and block frames from other MAC addresses.
deny = Block frames from MAC addresses that you specify
and allow frames from other MAC addresses.
and allow frames from other MAC addresses.