Yamaha RX-V2700 User Manual

The library name (ex. L;DVD) and the name of the 
selected input area (ex. DVD) appear alternately in 
the display window on the remote control.

y

• You can set a remote control code of a different type of 

component to an input area. Press l / h repeatedly to 
change the library (component category).
Library choices: L;DVD, L;DVR, L;LD, L;CD, L;CDR, 

L;MD, L;TAP (tape), L;TUN (tuner), 
L;AMP, L;TV, L;CAB (cable), 
L;SAT (satellite), L;VCR

• If you want to setup for another input area, press the input 

selector button or 

, or press SELECT k / n repeatedly to 

select the input area.

• Be sure to press and hold LEARN for at least 3 seconds, 

otherwise the learning process will start.

• If you do not complete each of the following steps within 

30 seconds, the setting mode will be automatically 
canceled. In this case, start over from step 2.

The four-digit code set for the selected component 
appears in the display window.

“0000” appears in the display window if no code has been set.

For a complete list of available remote control codes, 
refer to “LIST OF REMOTE CONTROL CODES” at 
the end of this manual.

“OK” appears in the display window on the remote 
control if setting was successful.
“NG” appears in the display window on the remote 
control if the setting was unsuccessful. In this case, 
start over from step 3.

y

If you continuously want to set up another code for another 
component, press the input selector button, or 
SELECT k / n repeatedly to select the component, then 
repeat steps 2 through 5.

p

y

If operation is not possible and the manufacturer of your 
component has more than one code, try each of them until 
you find the correct one.

• “ERROR” appears in the display window on the remote control 

if you press a button not indicated in the respective step, or 
when you press more than one button simultaneously.

• The supplied remote control does not contain all possible codes 

for commercially available audio and video components 
(including YAMAHA components). If operation is not possible 
with any of the remote control codes, program the new remote 
control function using the learn feature (see “Programming 
codes from other remote controls”) or use the remote control 
supplied with the component.

• Functions programmed using the learn feature take priority over 

remote control code functions.