Yamaha RX-V2700 User Manual

■

Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals and select either “INT:[SP1]” or 
“INT:[SP2]” for “Zone2 Amplifier” or “Zone3 Amplifier” (see page 104).

Connect the Zone 2 or Zone 3 speakers directly to the SP1 and SP2 speaker terminals and select “Both” for “Zone2 
Amplifier” or “Zone3 Amplifier” (see page 104).

You can select the zone you want to control by using the 
control buttons on the front panel or on the remote control. 

■

y

Once MASTER ON/OFF on the front panel is pressed 
inward to the ON position, you can also press POWER and 
STANDBY on the remote control to turn on the main zone, 
Zone 2 and Zone 3.

Each time you press ZONE CONTROLS, the front 
panel display changes as shown below, and the 
indicator for the currently selected zone flashes for 
approximately 5 seconds. However, no indicator 
flashes when the main zone is selected.

Controls the Zone 2 amplifier or tuner functions.

Controls the Zone 3 amplifier or tuner functions.

The SP1 or SP2 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or 
more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low 
impedance load resulting in amplifier damage. See this owner’s manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This 
information is found on the back panel of your Receiver.

R

L

R

L

R

L