Yamaha RX-V2700 User Manual

This unit starts the auto setup procedure. Loud test 
tones are output from each speaker during the auto 
setup procedure. During the setup procedure, 
“Measuring...” appears in the GUI screen. We 
recommend getting out of the room while thus unit is 
in the auto setup procedure. The necessary time for 
the auto setup procedure depends on the environment 
of the listening room and connected speaker (from 30 
seconds to 3 minutes).

y

• To stop the Auto Setup procedure and set this unit to the 

pause mode, press one of the cursor buttons (

k

 / n / l / 

h) or ENTER. In the pause mode, press k to retry the 
procedure, and 

l 

to cancel the Auto Setup procedure.

• If an error message appears and this unit stops the setup 

procedure, see the “Auto Setup” section in 
“TROUBLESHOOTING” on page 138, and after carrying 
out the remedy, retry the Auto Setup procedure.

• Press n and select “Setup” to set the measured 

values.

• Press k and select “Retry” to retry the Auto Setup 

procedure.

• Press h and select “Detail” to view information 

about measurement results and warning messages. 
For more details about warning messages, see the 
“Auto Setup” section in “TROUBLESHOOTING” 
on page 138.

• Press l and select “Exit” to exit from the Auto 

Setup procedure. If you select “Exit”, “Don’t 
Setup?” appears on the screen. To set the measured 
values and exit, select “Yes”. To cancel the settings 
and exit, select “No”.

y

If you are not satisfied with the results or want to manually 
adjust each parameter, set the parameters in “Basic” (see 
page 95).

• If you change speakers, speaker positions, or the layout of 

your listening environment, run “Auto Setup” again to 
recalibrate your system.

• The distances displayed in the “Distance” results may be 

longer than the actual distance depending on the 
characteristics of your subwoofer.

• In the “Equalizing” results, different values may be set for 

the same band to provide finer adjustments.

• After you have completed the “Auto Setup” procedure, be 

sure to disconnect the optimizer microphone.

• The optimizer microphone is sensitive to heat. Keep it 

away from direct sunlight and do not place it on top of this 
unit.

■

Use this feature to review the result of the auto setup.