Yamaha RX-V2700 User Manual

• This menu item is not available and hence not visible in the GUI 

menu if “Conversion” is set to “Off” (see page 93).

• When you set “TV FORMAT” in “ADVANCED SETUP” to 

“NTSC” (see page 127), “480p” appears in the choices of 
“HDMI Up-Scaling”, and when you set “TV FORMAT” to 
“PAL”, “576p” appears in the choices of “HDMI Up-Scaling”.

■

Use this feature to select the adjustment of aspect ratio for 
HDMI video signal sources.
Choices: 

, 16:9 Normal, Smart Zoom

• Select “Through” if you do not make any adjustments 

to the aspect ratio for HDMI video signal sources.

• Select “16:9 Normal” to display video images with 4:3 

of aspect ratio on your video monitor with 16:9 of 
aspect ratio. Black stripes appear on the right and left 
sides as a result.

• Select “Smart Zoom” to fit video images with 4:3 of 

aspect ratio to your video monitor with 16:9 of aspect 
ratio.

• When “HDMI Up-Scaling” is set to “Through”, you cannot 

make any adjustments to “HDMI Aspect”.

• When “HDMI Aspect” is set to “Smart Zoom”, the video 

images of the edge of the video monitor are rather stretched.

• When the video signals are input at HDMI IN jacks or the 

signals are input with 720p or 1080i of resolution, the setting of 
“HDMI Aspect” does not affect the video signals output at the 
HDMI OUT jack.

■

Use this feature to activate or deactivate the short message 
display function.
Choices: Off, 

• Select “On” to activate the short message display 

function. The contents of the front panel display appear 
at the bottom of the screen each time you operate this 
unit.

• Select “Off” to deactivate the short message display 

function.

The short message display does not appear in the following cases:

– when the component video signals with 720p, 1080i or 1080p 

resolutions are input

– when HDMI video signals are input

■

Use this feature to set the amount of time to display the 
iPod or NET/USB menu on the video monitor after you 
perform a certain operation.
Choices: Always, 10sec, 

• Select “Always” to display the menu screen 

unceasingly during an operation.

• Select “10sec” to turn off the menu screen 10 seconds 

after you perform a certain operation.

• Select “30sec” to turn off the menu screen 30 seconds 

after you perform a certain operation.