Sony NHF800 User Manual

12

A key having no particular description in the text, indicates a set
key.

Preparation:
Copy the “TestMode_Enter_For_900_800_700_600_600D_
Ver***.exe” folder of the PC application of the latest version to
your PC in advance. (operating system: Windows 2000, Windows
XP)
Also, when using this application, the SonicStage Ver. 2.0 or 2.1 is
necessary, and install it in your PC in advance.

1. If a Simple Burner has run on the PC, finish it (including the

one that is resident in the task tray).

2. Start the “TestMode_Enter_For_900_800_700_600_600D_

Ver***.exe”.

3. Insert the fully charged Ni-MH rechargeable battery (NH-

7WMAA).

4. Open and close the top panel of the main unit to wait until the

system reading finished.

5. Connect the main unit and PC by USB cable.
6. Check by device manager screen from property of “My

computer” that the set is recognised to your PC normally.

7. Click the [Enter TestMode] button on the screen of application
8. Disconnect the USB cable, when “OK” message is displayed

on the application screen.

9. Remove the battery.

Screen of the PC application “TestMode_Enter_For_900_800_
700_600_600D_Ver***.exe”
(“***” is version number)

Once the test mode is activated with this application, the test mode
is then activated forcibly by only turning on the power.
After the repair completed, be sure to release the test mode by using
this application once more.

• When the test mode becomes active, first the Display Check

mode is selected.

• Other mode can be selected from the Display Check mode.

• When the test mode is set, the LCD repeats the following

display.

“

00#”: Model type 005 (MZ-NH700)

004 (MZ-NHF800)

“

*.***”: Microcomputer version

• When the

X

key is pressed and hold down, the display at that

time is held so that display can be checked.

1. If a Simple Burner has run on the PC, finish it (including the

one that is resident in the task tray).

2. Start the “TestMode_Enter_For_900_800_700_600_600D_

Ver***.exe”.

3. Insert the fully charged Ni-MH rechargeable battery (NH-

10WM).

4. Open and close the top panel of the main unit to wait until the

system reading finished.

5. Connect the main unit and PC by USB cable.
6. Check by device manager screen that the set is recognised to

your PC normally.

7. Click the [Exit TestMode] button on the screen of application
8. Disconnect the USB cable, when “OK” message is displayed

on the application screen.

9. Remove the battery.

24

SYNC

All lit

All off

Microcomputer

version

display

REC

00#

Ver *.***