Yamaha AVENTAGE RX-A1020 User Manual

CONFIGURATIONS

➤ Configuring various functions (Setup menu)

En

Automatically optimizes the speaker settings (YPAO).

Registers two speaker setting patterns and switches between them.

Copies the “Setting Pattern” parameters in the specified direction.

Selects a speaker system.

Selects the size of the front speakers.

Selects whether or not a center speaker is connected and its size.

Selects whether or not surround speakers are connected and their size.

Selects whether or not surround back speakers are connected and their size.

Selects whether or not front presence speakers are connected.

Selects whether or not a subwoofer is connected and its phase.

Sets the speakers to produce the front channel low-frequency components.

Sets the lower limit of the low-frequency component that can be output from speakers whose size is set to “Small”.

Sets the distance between each speaker and listening position.

Adjusts the volume of each speaker.

Adjusts the tone with an equalizer.

Enables/disables the test tone output.

Enables/disables the Lipsync adjustment for each input source.

Selects the method to adjust the delay between video and audio output.

Adjusts the delay between video and audio output manually.

Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.

Sets the maximum volume to prevent excessive loudness.

Sets the initial volume for when this receiver is turned on.

Selects whether to output video signals during the Pure Direct mode.

Selects whether to automatically adjust the CINEMA DSP effect level. 

Enables/disables the video signal processing (resolution and aspect ratio).

Enables/disables HDMI Control. You can also configure the relevant settings (such as ARC and TV audio input).

Selects a device to output audio.

Select whether to output videos/audio (input through HDMI jacks) to the TV when the unit is in standby mode.