Pelonis HC-461 User Manual

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

• 

Place the heater on a firm level surface free from obstructions, and at least 3 ft. 
away from any wall and any other objects such as furniture, curtains, plants or 
combustible material. 

 

• 

With the Power Button “A” in the ”OFF” position, plug the heater into a 

grounded 120V outlet. 

 

• 

Turn the heater ”ON” by pressing the Power Button “A”.  The Power Indicator 
Light “D” will illuminate. 

 

• 

Set the desired temperature by pressing the Thermostat Control button “UP” to 
increase the temperature or “DOWN” to decrease the temperature.  The 

desired temperature will be set after the LED display stops flashing. 

 

 

 
 
 
 
 
 
 
 
CAUTION:  This heater includes a Thermal Cut-Off Overheat Protection System that 
shuts the heater off if it overheats due to abnormal conditions.  If this occurs, turn the 

heater ”OFF”, unplug it, and inspect and remove any objects on or adjacent to the 
heater.  Allow it to cool for a few minutes, plug it back in, and resume normal operation.

Your Disc Furnace is built to last and deliver outstanding performance for years.  Unlike 
other portable heaters, it uses a patented electronic temperature control that 

automatically monitors the exact room temperature and compensates for heat loss.  As 
a result, maximum comfort and energy efficiency are realized. 

The Room Temperature Display C” displays the actual room temperature when the 
heater is plugged in or during operation.   When the heater is operating and the room 

temperature near the heater reaches the desired set temperature, the Temperature Set 
Light “E” will illuminate.  Note: To turn off the room temperature display, you must 
unplug the heater. 
 

To view the set temperature at any time during the heater’s operation, press the 
Thermostat Control “B” button “UP” or “DOWN”.  The Room Temperature Display “C”
will flash the desired temperature that has been set.  When the display stops flashing, it 

will change to show the actual room temperature. 
 

For most efficient heating, place the heater on the floor where the air is cooler, and 

about 3 feet from any wall.  To heat your room, the heater will be most efficient when 
placed near an outside door, the bottom of a staircase, or where colder air is most 

likely to be entering the room. 
 

The filter collects dirt and dust from air circulating through the heater.  To clean the 

filter, rinse it with warm water and allow it to dry before reinstalling. 
 

 

 

Carry Handle
(behind unit) 

Your heater is equipped with a polarized alternating current line plug (a plug having one blade 

wider than the other).  This plug will fit into the power outlet only one way.  This is a safety 
feature.  If you are unable to insert the plug fully into the outlet, try reversing the plug.  If the 
plug should still fail to fit, contact your electrician to replace your outlet.  DO NOT defeat the 
safety purpose of the polarized plug. 

            Power Button                     Room Temperature Display          Temperature Set Light

            Thermostat Control          Power Indicator Light