Regency U32S-LP5 User Manual

U32S-5 FPI Direct Vent Gas Insert

The Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi replace is higher 
than the hearth or to raise the fi replace. The faceplate is assembled fi rst and then the hearth trim is attached to the 
faceplate. There are 2 Hearth Trim options; a 2" and a 4".

1)  Attach the Hearth Trim to the bottom of the faceplate side 

panels with the screws provided (3 per side) as shown in  
diagram 1.  The holes in the Hearth Trim are oblong so the 
trim can be adjusted inwards or outwards as needed to suit 
fi nishing.

 

NOTE: Don't tighten the screws down completely at this point, 
do a trial fi t to the unit, make any necessary adjustments, 
when trim fi ts properly, tighten the screws.

1)  Secure the two 2" hearth trim pieces together as shown in 

diagram 2. Secure using the 2 screws provided.

2)  Attach the now 4" Hearth Trim to the bottom of the faceplate 

side panels with the screws provided (3 per side) as shown 
in  diagram 1.  The holes in the Hearth Trim are oblong so 
the trim can be adjusted inwards or outwards as needed to 
suit fi nishing.