Hearth & Home Technologies SFE-ST User Manual

  4 

Hearth & Home Technologies Inc. • SFE-ST • 4050-510 Rev A •

05/08

30.3 in.

(770 mm)

17 in.

(432 mm)

.5 in.

(13 mm)

26 in.

(660 mm)

18 in.

(457 mm)

 

Voltage . . . . . . . . . . . . . . . . . . . . . . 120 V AC, 60 Hz

 

Total Amps . . . . . . . . . . . . . . . . . . . . . . . .  0.15 AMP

 

Total Watts . . . . . . . . . . . . . . . . . . . . . . . . .  18 Watts

Note:  All wiring must be completed prior to fi nishing  the 
unit.

For supply connections use No. 14 AWG or larger wires. 
Use copper wire only. Connect only to a 15 AMP branch 
circuit. 

•  Remove the screws securing the junction block cover.

•  Wire to a properly grounded, 120 volt, 60 Hz, 15 AMP 

circuit

•  Ensure all junction block connections are tight.
•  Replace the cover and retaining screws.
•  All components and wiring may be inspected by removing 

the top inter-panel through the appliance front opening.

•  Choose an appliance location and frame as shown 

below.

•  It is important to allow for fi nished face when setting the 

depth of the frame.

•  The appliance can now be positioned in the opening.
•  Level it with shims if necessary, and attach the unit to the 

frame using the nailing fl anges provided.

C

B

A

30 1/2

26 1/4

17

775

667

432

The optional WSK-21 Wall Switch contains a single pole low 
voltage switch.

Maximum run distance is 30 ft. (9.14 m) with 20 gauge solid 
copper low voltage thermostat wire. Connect the leads from 
the switch to the #2 and #3 terminals on the terminal block 
located under a cover on the lower side of the inner top.

The door must be removed to access the terminal block.