Genie 37026500123 User Manual

22

1. Testing.

• Open garage door using Wall Control.

– Place a 2" x 4" board (laid flat) under center

of garage door opening (FIG. 6-6). 

• Close door using Wall Control.
• When door contacts board, the door must stop 

(within 2 seconds) and reverse direction 
returning to open position.

2. Adjustment.

• If the door does not properly reverse.

– Check to see if door has "close" limit 

programmed. It should not have reached its 
"close" limit before hitting board.

– If the door STOPS but does not reverse, 

decrease "CLOSE FORCE" control 
setting slightly (turn it counter-clockwise).

• Test again. Repeat as necessary until door 

reverses upon contacting board. 

1. Press and hold both of the "SET" buttons 

( &  ) together until the green indicator 
light blinks (about 5 seconds). 

2. All close and open travel limit settings are 

erased. Then follow the steps above to 
reprogram close and open travel limits.

1. By turning the "Close Force Control" 

wise, the DOWN force can be increased. By 
turning the "Close Force Control" 

clockwise, the DOWN force can be decreased. 
Set the DOWN force level at the minimum force 
required to close door without reversing.

2. Once the desired level is selected, this stores the 

necessary force level for the DOWN direction in memory.

3. By turning the "Open Force Control"

clockwise, 

the UP force can be increased. By turning the 
"Open Force Control"

counter-clockwise, the UP

force can be decreased. Set the UP force level at 
the minimum force required to open door without 
stopping.

4. Once the desired level is selected, this stores 

the necessary force level for the UP direction 
in memory.

Down Force

Control 

Adjustment

Up Force

Control 

Adjustment

ROTATE

CLOCKWISE

ROTATE

COUNTER-CLOCKWISE

(Increasing Force)

(Decreasing Force)

Force Control Adjustment.