DKS Enterprises 9310 User Manual

Mount operator to pad using 3/8 or 1/2 sleeve anchors.
See page 18-19.

1

2

Attach chain.  Adjust chain to allow approximately 1-inch of sag per 10-feet of gate width.
Be sure to remove the pin from the breather plug.
See page 20-21.

3

Connect supply voltage as described in section 2.1.  Be sure power is OFF!
See page 26.

4

Connect control wiring as shown.  Radio receiver connects to terminals 1-2-3.  Full open
input devices connect to terminals 4 and 13.  Partial open input devices connect to
terminals 5 and 13.  Terminals 1 and 13 are the same - 24 volt common.

5

Connect secondary entrapment prevention devices.
See page 27.

6

Connect in-ground loop wires to REVERSE and EXIT loop detectors as required.
See page 28.

7

Set close timer ON or OFF (SW-1, switch 2) as required.  If gate system does not utilize in-
ground loop system or photo-cells, timer must be OFF.
See page 34-35.

8

Push gate to open position.  Adjust OPEN limit nut to activate open limit switch.  Push gate
closed.  Adjust CLOSE limit nut to activate close limit switch.
See page 36.

9

Turn power ON.  Give gate an open command.  If gate runs towards CLOSE position, turn
power off.  Change setting of direction switch (SW-1, switch 1) and then turn power ON.
Give gate an open command.  Adjust limit nuts as necessary.
See page 36.

10

Adjust both open and close inherent reverse sensitivity.  NOTE: Operator will assume a
"soft shutdown" during sensitivity adjustments.  This will require operator open input to be
activated to resume normal operation.
See page 37.

Page 4 

 

9310-065-E-5-07