Gianni Industries 981-10 User Manual
Copyright All Rights Reserved.
P-MU-982-10 Ver. A Publish:2004.05.01 Page: 3/ 4
P-MU-982-10 Ver. A Publish:2004.05.01 Page: 3/ 4
READHEAD
Note
When using a strike with DC, the relay contacts will be damaged by arcing due to back EMF
when the contact opens. Use a IN4001 diode as shown on the drawing to prevent this damage.
when the contact opens. Use a IN4001 diode as shown on the drawing to prevent this damage.
Push-button
A push-button may be connected to allow remote operation of the door strike relay in the same
manner as if a tag is read. The push button must be normally open and is wired between the two
Exit terminals.
manner as if a tag is read. The push button must be normally open and is wired between the two
Exit terminals.
Warning: The installer should earth himself before making contact with the controller
board to avoid electrostatic discharge into the unit.
board to avoid electrostatic discharge into the unit.
Position
The Easiprox read head works on the principle of radiating a magnetic field from a coil. The
field generated by the coil will be affected by the close proximity of metal. Ideally the Easiprox
field generated by the coil will be affected by the close proximity of metal. Ideally the Easiprox