Petsafe PPA11-13098 User Manual

6 

2

Connection 
Bar

Factory 
Installed 
Screws 
On Each 
Side

Bottom
Door
Section

 

  

NOTE: 

If you purchased a 96” Patio 

Panel, fi rst assemble the bottom section 
to the top section before proceeding with 
the installation. Remove the four factory 
installed screws from sides of connection 
bars on bottom door section. Align and slide 
connection bars on bottom section into top 
section. Reinstall and tighten the four screws 
through the four pre-drilled holes on sides of 
top door section into the connection bars.

   

NOTE: 

Remove all packaging materials, 

including cardboard inserts inside the height

 

    

adjuster.

2B The Freedom

™

 Patio Panel Pet Door inserts 

into the opening in your sliding glass door 
against the doorjamb. Your sliding glass door 
will close against the Patio Panel.

With sliding glass door open, insert top of Patio 
Panel with height adjuster into upper door track 
on interior side of sliding glass door. Lift up and 
position bottom of Patio Panel into lower door 
track on interior side of the sliding glass door. 
Ensure the side of the Patio Panel showing 
fl ap screw heads is on the interior side of your 
sliding glass door.

    NOTE: 

You may need to pull down the height adjuster to fi t the Patio Panel in your 

sliding glass door track. Firmly pull down one side and then the other.

2C Move the Patio Panel against the 
doorjamb.

 The Patio Panel should fi t fl ush 

against the doorjamb without any gaps. Make 
sure the height adjuster is fully extended and 
not tilted to one side. Ensure you are satisfi ed 
with the fi t of the Patio Panel before drilling