Panasonic NV-DS30A User Manual

Page of 60
10
Power Supply
ª Using the AC Adaptor
1
Connect the DC Input Lead to the [DC IN] Socket on 
the Movie Camera.
2
Connect the DC Input Lead to the AC Adaptor.
3
Connect the AC Mains Lead to the AC Adaptor and 
the AC mains socket.
≥The AC Mains Leads outlet plug cannot be pushed fully into 
the AC Adaptor socket. A gap will remain as shown 
1
.
Before connecting or disconnecting the power supply, set the 
[VCR/OFF/CAMERA/M-CARD] Switch on the Movie Camera to 
[OFF] and make sure that the [POWER] Lamp is not lit.
ª Using the Battery
Before use, fully charge the Battery.
1
1
1
1
Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Input Lead 
is connected to the AC Adaptor, disconnect them.
≥The [POWER] Lamp and [CHARGE] Lamp lights up, and 
charging starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
2
2
2
2
Attach the charged Battery to the Movie Camera.
To Remove the Battery
Set the [VCR/OFF/CAMERA/M-CARD] Switch 
2
 to [OFF], and 
while pressing the [BATT RELEASE] Lever 
3
, slide the Battery to 
remove it.
When attaching or removing Battery, set the [VCR/OFF/
CAMERA/M-CARD] Switch to [OFF] and make sure the 
[POWER] Lamp is not lit.
ª Using the Car Battery Charger
If you use the Car Battery Charger (VW-KBD2E; optional), you can 
supply power to the Movie Camera and charge the battery inside 
your car. For further information, refer to the instruction manual of 
the Car Battery Charger.
≥Be sure to start the car engine before you connect the Car Adaptor 
Cord, otherwise the fuse may blow.
≥For other notes concerning this item, see page 46.
3
2
1
1
1
2
3
2
BATT RELEASE
VCR
OFF
CAMERA
M-CARD
A-ENG.book  10 ページ  2002年1月28日 月曜日 午前11時32分