Panasonic NV-DS30A User Manual

Watch for Condensation even before the 
Condensation Indication is displayed.
≥Because condensation takes place gradually, the 

Condensation Indication may not be displayed 
during the first 10 to 15 minutes of condensation 
formation inside the Movie Camera.

≥In extremely cold places, condensation may freeze 

and form frost. In this case, the frost melts first, 
thus forming condensation, and then it takes 
another 2 to 3 hours to eliminate the condensation.

When the Lens is Fogged:
Set the [VCR/OFF/CAMERA/M-CARD] Switch to 
[OFF] and leave the Movie Camera in this condition 
for about 1 hour. When the lens temperature 
becomes close to the ambient temperature, the fog 
disappears naturally.

ª Video Head Clogging and Care

If the heads (the parts that make contact with tape) 
are dirty, mosaic-pattern noise may appear on the 
playback image, or the screen as a whole becomes 
black. If the heads are extremely dirty, recording 
performance deteriorates, and, in the worst case, 
the Movie Camera cannot record at all.
Causes of Dirty Heads
≥Large quantity of dust in the air
≥High-temperature and high-humidity environment
≥Damaged tape
≥Long operating hours
Using Mini-DV Format Digital Video Head 
Cleaner

1] Button, and 

∫] Button. (Do not rewind the tape.)

Notes:
≥Do not rewind every time you use the Head 

Cleaner. Rewind only when the tape reaches the 
end, and then use it again from the beginning in 
the same manner as before.

≥If the heads become dirty soon after cleaning, the 

tape may be damaged. In this case, immediately 
stop using that Cassette.

≥Do not clean the heads excessively. (Excessive 

cleaning may cause excessive wear of the heads. 
If the heads are worn, images cannot be played 
back even after the heads are cleaned.)

≥If the dirty heads cannot be cleaned with the Head 

Cleaner, the Movie Camera needs to be cleaned 
at a service centre. Please consult a dealer.

≥Video Head Cleaners can be purchased from 

service centres.

≥Head cleaning due to dirty heads is not considered 

a malfunction of the product. It is not covered by 
the warranty.

Periodical Check-up
To maintain the highest image quality, we 
recommend replacement of worn parts, such as 
heads, etc., after approximately 1000 hours of use. 
(This, however, depends on operating conditions, 
such as temperature, humidity, dust, etc.)

ª Optimal Use of the Battery

Battery Characteristics
This Battery is a rechargeable lithium ion battery. Its 
ability to generate power is based upon the 
chemical reaction that takes place inside it. This 
reaction is susceptible to the surrounding 
temperature and humidity, and, if the temperature is 
too high or too low, the operating time of the Battery 
becomes shorter. If the Battery is used in an 
extremely cold environment, the Battery may 
operate only for about 5 minutes. If the Battery 
becomes extremely hot, a protective function may 
operate, and the Battery may become unusable for 
a while.
Be Sure to Detach the Battery after Use
Be sure to detach the Battery from the Movie 
Camera. (If it is left attached to the Movie Camera, a 
minute amount of current is consumed even when 
the Movie Camera power is off.) If the Battery is left 
attached to the Movie Camera for a long time, over 
discharge takes place. The Battery may become 
unusable after it is charged.
Disposing of an Unusable Battery
≥The Battery has a limited life.
≥Do not throw the Battery into fire because it may 

cause an explosion.

Always Keep the Terminals of the Battery Clean
Prevent the terminals from getting clogged with dirt, 
dust, or other substances.
If you drop the Battery accidentally, check to see if 
the Battery body and terminals are deformed.
Attaching a deformed Battery to the Movie Camera 
or AC Adaptor may damage the Movie Camera or 
AC Adaptor.

A-ENG.book  52 ページ  ２００２年１月２８日 月曜日 午前１１時３２分