Smartdisk Secure Digital Memory Card User Manual
FlashPath User Guide 13
•
•
•
•
•
•
Maintenance
To change batteries:
1
Place your FlashPath on a flat surface and gently press down on the battery cover.
2
Turn each cover counter-clockwise until the battery compartments are open.
3
Install new lithium button cells. Make sure that the positive side (marked with a + sign) is up and
that the side spring contact is located on the side of the battery. The contact must not be trapped
beneath the battery.
that the side spring contact is located on the side of the battery. The contact must not be trapped
beneath the battery.
Caution: Never insert Flashpath into a floppy drive without batteries in place and the
covers properly closed.
covers properly closed.
Cleaning
Remove the FlashPath from the floppy disk drive; remove the Secure Digital Memory Card
or MultiMediaCard from the FlashPath. Use a clean, dry, lint free cloth or cotton swab to
wipe off any oil, dust, or particles in the slot on the front and the back of the FlashPath.
If necessary, clean the remainder of the outside of the FlashPath with a clean, lint free cloth
or paper towel and denatured alcohol. After cleaning, place FlashPath in its jewel case for
storage.
or MultiMediaCard from the FlashPath. Use a clean, dry, lint free cloth or cotton swab to
wipe off any oil, dust, or particles in the slot on the front and the back of the FlashPath.
If necessary, clean the remainder of the outside of the FlashPath with a clean, lint free cloth
or paper towel and denatured alcohol. After cleaning, place FlashPath in its jewel case for
storage.
Uninstalling FlashPath Software
To uninstall FlashPath software:
1
Click on Start > Settings > Control Panel.
2
Select Add/Remove Programs. The Add/Remove Programs Properties window opens.