Panasonic AJ-SD93 Operating Guide

– 8 –

Digital Video Cassette Recorder AJ-

When this button is pressed, the tape is unloaded and
the cassette is ejected automatically a few seconds
later.
When CTL display has been selected for the counter
display, the display is reset.
EJECT button operation can be enabled or disabled
with setup menu No. 115 (EJECT SW INH).

This is selected to control the unit from an external
source using the REMOTE connector.
REMOTE: Set to this position to control the unit using

the 9-pin REMOTE connector and IEEE
1394 AV/C commands.

LOCAL   : Set to this position to control the unit using

the controls on the unit's operation panel.

This switch is used to enable or disable recording on
the cassette tape.
ON:

Recording on the cassette tape is disabled 
(inhibited).
In this state, the REC INH lamp lights on the display
panel.

Recording on the cassette tape is enabled so long
as the accidental erasure prevention mechanism on
the cassette tape is set to enable recording.

This button is used to select the scale display for the
audio level meter.
FULL mode

: The standard scale (– 

∞ to 0 dB) is

selected.

: The scale in 0.5 dB increments is

selected. The 

position indicates

the standard level of –20 dB (–18 dB).
(See page 11)

This button is used to select the audio signals which
are to be output to the AUDIO MON L and R
connectors.
Each time the button is pressed, the audio signals to
be output to the AUDIO MON L or R connector are
changed in the following sequence.

Which signal is currently selected is displayed by the
lighting of the L or R lamp on the level meter display.

When stereo headphones are connected to the
headphone jack, the sound can be monitored using
the headphones during recording or playback.

These knobs are used to adjust the recording and
playback level of the PCM audio signals (CH1, CH2,
CH3 and CH4).
Whether the recording level or playback level is to be
adjusted is selected using the audio level control

selector switch 

.

Note:
The level of the IEEE 1394 digital input/output audio
signals cannot be adjusted.

UNITY: At this position, the audio signals are recorded

or played back at a fixed level regardless of
the position of the audio level control knobs

.

: At this position, the audio signals are

recorded at the level which has been adjusted

by the audio level control knobs 

.

: At this position, the audio signals are played

back at the level which has been adjusted by

the audio level control knobs 

.

Note:
It is not possible to set this switch so that both the
recording level and playback level can be adjusted.
When REC is selected, UNITY (fixed level) is set for
the playback level; when PB is selected, UNITY is set
for the recording level.

  [CH1]      [CH3]      [CH1]      [CH2]      [CH3]      [CH4]

R :   [CH2]      [CH4]      [CH1]      [CH2]      [CH3]      [CH4]

[CH1+CH2]      [CH3+CH4]
[CH1+CH2]      [CH3+CH4]

→

→

→

→

→

→

→