Powermatic 719T User Manual

Page of 24
 
11
Installing Chisel and Bit 
Referring to Figure8
1. Loosen 
the 
lock screw.  
2.  Insert the chisel bushing into the head with 
the hole facing forward to line up with the 
lock screw. Screw in the lock screw just 
enough so the screw extends into the hole 
of the bushing, holding it in place. 
3. Push the chisel up through the bushing
bringing it to rest against the shoulder of 
the bushing. Then lower the chisel 
approximately 1/16" to 3/16", depending on 
the type of wood being worked. 
Note: Set the slot in the side of the chisel to the 
left  
or right, if the workpiece is to be moved 
laterally and front or back if it is to be moved 
from front to back. Move the workpiece so that 
the slot in the chisel is releasing chips into the 
already cut part of the workpiece (see 
Figure 19). 
4. Tighten 
the 
lock screw to hold the chisel in 
place. 
5. Push 
the 
bit up through the chisel opening 
as far as it will go. Lock the drill bit in place 
with the chuck key
6. Loosen 
the 
lock screw and push the chisel 
up against the bushing, then tighten the 
lock screw. This should provide the proper 
distance between the points of the chisel 
and the bit
Note: This would be a good place to make sure 
that the chisel is parallel to the workpiece. See 
the Chisel Parallel to Workpiece section. 
 
 
Work Stop 
The work stop can be mounted to either end of 
the table through the holes in the back of the 
table, as shown in Figure 9. It is tightened into 
place by means of thumbscrews. 
 
 
 
 
 
 
 
 
Figure 8 
 
 
 
 
 
 
 
 
 
 
 
THUMBSCREWS 
HOLES
 
 
Figure 9