Panasonic VDR-D310 User Manual
35
LSQT1145
Setup
“SIDE B” recording/playback side is the side with
the “SIDE A” mark.
the “SIDE A” mark.
A “SIDE A” mark
B The opposite side is the “SIDE A” recording/
B The opposite side is the “SIDE A” recording/
playback side.
≥ Do not use excessive force when opening the
cover.
≥ Do not touch the pickup lens or the recording/
playback side of the disc.
This may impair recording and playback.
This may impair recording and playback.
≥ Insert the disc securely to prevent damage.
≥ When you open the cover, the ACCESS/PC
≥ When you open the cover, the ACCESS/PC
lamp flashes red. Do not leave the cover open.
≥ If the cover is open, the power will not turn off
even if the OFF/ON switch is set to OFF.
≥ If the disc is not correctly inserted, the cover
will not close. Never try to forcibly close the
cover. This could cause damage. Reinsert the
disc properly.
cover. This could cause damage. Reinsert the
disc properly.
≥ If a single sided disc is inserted into the unit
with the printed label facing the inside, an error
message will appear. Remove the disc and
reinsert it with its recording/playback side
facing the inside.
message will appear. Remove the disc and
reinsert it with its recording/playback side
facing the inside.
≥ Do not allow the recording/playback side to
become dirty or scratched.
≥ Do not remove the battery pack or disconnect
the AC adaptor while removing the disc or until
power is completely turned off. If you do, the
cover will not open. If this happens, reattach
the battery pack or reconnect the AC adaptor,
slide the DISC EJECT lever once, and then
release it. A repair disc message may be
displayed when the power is turned back on.
(l 122, About recovery)
power is completely turned off. If you do, the
cover will not open. If this happens, reattach
the battery pack or reconnect the AC adaptor,
slide the DISC EJECT lever once, and then
release it. A repair disc message may be
displayed when the power is turned back on.
(l 122, About recovery)
≥ Do not insert anything other than the 8 cm (3z)
DVD-RAM, DVD-RW, DVD-R or DVD-R DL
disc into the disc compartment. Doing so could
cause malfunctions. (l 24, Examples of discs
disc into the disc compartment. Doing so could
cause malfunctions. (l 24, Examples of discs
that cannot be used on this unit)
≥ Do not touch the pickup lens or other parts
inside the disc compartment. Be sure not to
touch the area around the pickup lens for it
becomes extremely hot.
becomes extremely hot.
Inserting/removing an SD
card (VDR-D310/
VDR-D230)
card (VDR-D310/
VDR-D230)
Before inserting/removing an SD card, be
sure to set the OFF/ON switch to OFF.
sure to set the OFF/ON switch to OFF.
1
Set the OFF/ON switch to OFF to
turn off the power.
turn off the power.
≥ Check that the status indicator has gone off.
2
Slide the card slot cover to open.
DV
D-R
AM / SIDE
A
A
B
After inserting a disc/After recording
finishes
While the ACCESS/PC lamp is lit, the disc is
rotating and disc information is being
recorded. If the power supply is interrupted at
this time, the disc may become unusable. Do
not disconnect the AC adaptor or remove the
battery. Also, do not strongly shake or cause
impact to the unit.
finishes
While the ACCESS/PC lamp is lit, the disc is
rotating and disc information is being
recorded. If the power supply is interrupted at
this time, the disc may become unusable. Do
not disconnect the AC adaptor or remove the
battery. Also, do not strongly shake or cause
impact to the unit.
If the SD card is inserted or removed while the
OFF/ON switch is set to ON, this unit may
malfunction or the data recorded on the SD
card may be lost.
OFF/ON switch is set to ON, this unit may
malfunction or the data recorded on the SD
card may be lost.
LSQT1145.book 35 ページ ２００６年１２月２８日 木曜日 午前９時３４分