Nikon Coolpix 995 User Manual

69

68

Å Set the Exposure mode to 

Â

, and place the camera on a tripod or secure

position, then rotate the Command dial to set the shutter speed indication to

bu1b

(next after 8 sec.) to enable long time (BULB) exposure.

Í Pressing the Shutter release button once opens the shutter up to 60 sec.

• BULB can only be set when Single mode is selected in the Continuous

Shooting menu (p. 99).

• The Speedlight is canceled if BULB exposure is set.
• During long-time exposure, selecting Noise Reduction On can reduce noise

in the form randomly spaced bright-colored pixels in the recorded image 
(p. 117).

Four Flash modes are available for use in various flash shooting
situations.

Flash mode can only be set when the built-in Speedlight is raised. The Flash
Cancel indication 

fi

is displayed in the Control panel and Monitor when the

built-in Speedlight is stowed.

The Speedlight does not fire with Infinity focus (p. 61), in Continuous Shooting
mode (other than Single mode) (p. 99), in Best Shot Selector mode (p. 102),
Lens mode (p. 106) or Int Flash Off mode (p. 133) even when the built-in
Speedlight is released.

* No indication is

shown in the
Monitor when
AUTO Flash
mode is selected.

• If the Red LED is pulsing slowly when the Shutter release button is lightly

pressed, the Speedlight is not fully charged and the shutter cannot be
released. Wait until the Speedlight is fully charged and release the shutter
again.

If the shutter speed is displayed in red when 1/2000 sec. shutter speed is
selected, stop-down aperture while confirming exposure on the Exposure meter
in the Monitor.

Detailed Oper

ation

COOLPIX995 (E)  01.5.30 0:40 PM  Page 68