Oregon Scientific PS-S02/PS-S02U User Manual
6
EN
GETTING STARTED
BATTERIES
Batteries are supplied with this product. Replace them
whenever the low battery signal ( ) displays. Remove the
compartment lid on the bottom of the unit. Be sure to match
the correct polarity, as shown in the battery compartment.
Before you close the lid, press the RESET button with the
point of a blunt object (such as a ball point pen).
Batteries are supplied with this product. Replace them
whenever the low battery signal ( ) displays. Remove the
compartment lid on the bottom of the unit. Be sure to match
the correct polarity, as shown in the battery compartment.
Before you close the lid, press the RESET button with the
point of a blunt object (such as a ball point pen).
NOTE Do not use rechargeable batteries.
AC POWER ADAPTER
An AC power adapter is supplied for use with the main
unit. You must connect the power adapter if you wish to
use the continuous projection feature. The jack is located
in the battery compartment.
An AC power adapter is supplied for use with the main
unit. You must connect the power adapter if you wish to
use the continuous projection feature. The jack is located
in the battery compartment.
NOTE If the AC power becomes unavailable, the unit will
automatically switch to battery power.
automatically switch to battery power.
SWITCH BETWEEN MODES
Press SELECT. The selected mode will flash. The display
will stop flashing if no key is pressed within 5 seconds.
Press SELECT. The selected mode will flash. The display
will stop flashing if no key is pressed within 5 seconds.
CHANGE SETTINGS
Press and hold SELECT for 2 seconds. Then, press UP
or DOWN to change each setting. Press SELECT to
switch between options.
Press and hold SELECT for 2 seconds. Then, press UP
or DOWN to change each setting. Press SELECT to
switch between options.