Sony EBS-SP10 User Manual

SP-TUNE User Manual 

 

9

These reserved channel numbers are based on the values selected in the service menu and could be setup 
in many different ways as shown below. 

 

26    - Composite video IN (Default is 126) 
97   - S-Video IN (Default is 127) 
108 - RGB+HV IN (Default is 128) 
2     - YPbPr IN (Default is 129) 
 
When a user changes to one of the channels above the appropriate input will display instead of the 

normal TV channel signal. 

 
Note that RGB and YPbPr inputs actually share the same connection (15-pin female VGA-like), so 

channels 128 and 129 change only interpretation of this input.  For instructions on selecting or changing a 
“channel” for an assigned input, please see section 7.6 “Map A/V Input to Channel” 

 
More advanced functionality differs in different operating modes, which is described in more detail 

below and in the subsequent chapters of this document. 

 

In the Stand-alone and Service modes, the SP-TUNE is controlled using one of directly supported IR 

transmitters by Sony. 

When no menu is active, usual keys of IR transmitter can be utilized to change volume level and 

switch channels. These control keys are: 

 

“VOLUME “ – volume up/down adjustment 

 

 

Change TV channel. Number and label (if was defined) of the new channel is shown at top of screen for 5 
seconds. 

 

 

 

Dialog: “SWITCH TO” – enter new channel number, several digits can be entered if necessary. Channel 
is switched to after a 3 seconds timeout (since the most recent digit is entered) or after pressing 
TV/Video/FM or R key. 

 

 

Enter the main configuration menu. See the Menu System chapter 
 

Enter selections for the menu.